Gledhill Repairs
Would you like to react to this message? Create an account in a few clicks or log in to continue.

PulsaCoil 2000 Immersion Heater fault - reset switch.

3 posters

Go down

PulsaCoil 2000 Immersion Heater fault - reset switch. Empty PulsaCoil 2000 Immersion Heater fault - reset switch.

Post  dmdrabble Thu Jun 13, 2013 9:23 am

Hello,

I have a Pulsacoil 2000 water heater, with a off peak Immersion heater problem. I have taken the external round cover off and found the reset button tripped the other night. I got lovely hot water the following morning. This morning, the water was cold again. The switch has tripped again.

The upper - on peak heater works fine during on peak.

Does anyone have any suggestions about why the switch would keep tripping?

dmdrabble

Posts : 5
Join date : 2010-06-27

Back to top Go down

PulsaCoil 2000 Immersion Heater fault - reset switch. Empty Re: PulsaCoil 2000 Immersion Heater fault - reset switch.

Post  Mario.S Sun Jun 16, 2013 1:00 am

Have you checked for any leaks on the lower immersion heater?, some leaking out of the rod stat pocket and short the electric on the stat. Otherwise sounds like a new rod stat ( immersion heater thermostat ) needed.
Hope this helps

Mario at Mario's Boiler Service

Mario.S

Posts : 224
Join date : 2011-12-10
Location : Fareham / Hampshire

http://www.marios-boiler-service.co.uk/

Back to top Go down

PulsaCoil 2000 Immersion Heater fault - reset switch. Empty Reply to Mario - Thermorod tripping

Post  dmdrabble Tue Jun 18, 2013 11:18 am

Mario,

Thanks for the reply. There aren't any leaks, so I've gone ahead and ordered an new rod. They are cheap enough to take a gamble.

Thanks to Mario and all on the Forum fopr posting such information. I have been able to find tips and ideas and to be honest, I wouldn't have know about the trip switch if someone else hadn't posted a similar comment.

I am moving out my flat flat in 5 weeks - just exchanged contracts - so the boiler problem couldn't have come at a worse time. Hopefully this will fix the issue, as the solicitors, etc have swallowed up a lot my money.

Hope there is a similar forum for my gas combi boiler at the house I'm buying.

David.

dmdrabble

Posts : 5
Join date : 2010-06-27

Back to top Go down

PulsaCoil 2000 Immersion Heater fault - reset switch. Empty Make sure it is the correct thermostat rod

Post  sunny.sahdev Wed Sep 11, 2013 3:03 am

Hi David,

Make sure the rod you purchased is a XB081 rod, any other rod with a lower temperature will not allow the system to work correctly.

You can order them via this link: Gledhill Pulsacoil 2000 Spares

sunny.sahdev

Posts : 383
Join date : 2013-08-21
Age : 38
Location : Vedhas Limited, 960 Capability Green

http://www.vedhas.co.uk/vedhas-what-we-do/pulsacoil-repair/#

Back to top Go down

PulsaCoil 2000 Immersion Heater fault - reset switch. Empty Re: PulsaCoil 2000 Immersion Heater fault - reset switch.

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum