Pump wont run

View previous topic View next topic Go down

Pump wont run

Post  s.taylorz on Mon Feb 08, 2010 1:40 pm

Hi

I have another problem with my daughters Pulsacoil 2000. Before she went on holiday, there were no problems, she comes back and no hot water. The heat store is hot but when the tap is turned on the pump wont run, there is 50 volts to the pump all the time even when there is no water flowing! I read in another post that the pump starts at about 50 volts and ramps up, well the voltage stays at 50 volts.

Any ideas.

PS

Best regards

Steve T

s.taylorz

Posts : 3
Join date : 2009-12-15

View user profile

Back to top Go down

Re: Pump wont run

Post  ab property services on Mon Feb 22, 2010 4:58 pm

hi seems like the pump is sticking, undo the big screw at the front then open hot tap, and spin the pump with small screwdriver

ab property services

Posts : 11
Join date : 2009-09-28
Location : west midlands

View user profile

Back to top Go down

Open tap and check voltage

Post  sunny.sahdev on Fri Sep 13, 2013 9:50 am

Try loosening the pump as instructed but also check voltage is increasing when you open your hot water tap. If the voltage is staying low as 50v, then it could be a sensor or PCB fault.

sunny.sahdev

Posts : 383
Join date : 2013-08-21
Age : 32
Location : Vedhas Limited, 960 Capability Green

View user profile http://www.vedhas.co.uk/vedhas-what-we-do/pulsacoil-repair/#

Back to top Go down

Re: Pump wont run

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum