Gledhill Repairs
Would you like to react to this message? Create an account in a few clicks or log in to continue.

How to change DHW Temperature?

4 posters

Go down

How to change DHW Temperature? Empty How to change DHW Temperature?

Post  GardinerG Sun Aug 07, 2011 4:47 am

Hi all, I have the Systemate III installed in my flat (single manual clock, no diagnostic lights visible on the front panel).

The problem I have is the Domestic Hot Water is so hot it hurts. Taking the front panel off and using SW2 it shows me the temperature is around 64 degrees (my old house it was set to around 55).

How on earth do I change it? Can it be changed with this version of the SMIII? I do not have the instruction manual, and the one I downloaded shows a 14 LED diagnostic / control panel I do not have.

I would really appreciate some help on this!

Thanks

Grant

GardinerG

Posts : 1
Join date : 2011-08-07

Back to top Go down

How to change DHW Temperature? Empty Re: How to change DHW Temperature?

Post  mike Sun Aug 07, 2011 6:10 am

Hi never seen one.
None in my area.
But looking at the System mate III down load from Gledhill.
Look at page 28.
Look at
12,13,14,15 and 22 all could be relevant.
But 22 the mixer valve would be my first choice.
If not speak to Gledhill tech at 60p per minute.
Which at £6.00p for 10 mins is cheaper than an engineers visit.
Post a reply when you have rectified your problem.
It may well help others.
Mike
MGC/H2O
Norflok

mike

Posts : 1747
Join date : 2009-10-08
Age : 71
Location : Norwich

http://www.mgch20.co.uk

Back to top Go down

How to change DHW Temperature? Empty Re: How to change DHW Temperature?

Post  MK Group Ltd Sun Aug 07, 2011 10:31 am

Hi Grant,

Have you tried turning the top of your mixing valve? If you have turned the mixing valve down then the mixing valve has failed and will need replacing.

Kind regards

Gary
MK Group Ltd
MK Group Ltd
MK Group Ltd

Posts : 301
Join date : 2010-04-03

http://www.mkgroupltd.co.uk

Back to top Go down

How to change DHW Temperature? Empty Re: How to change DHW Temperature?

Post  Midland Boilercare Sun Aug 07, 2011 11:36 am

Hi Grant

There are two versions of the Systemate 3, one that has three independant control boards (main ACB, pump speed board, and 14 LED display board), and the other has simply one main control board.
It sounds as though you have the later version of the Systemate 3 and have the single board. This is the same board that is used in the Systemate 2000 / Boilermate 2000 range that followed on from the 3 range, and as such, the hot water temperature is controlled via the DHW sensor and the PHE sensor together with the main board.
Excessive temperature of the hot water is usually down to either a scaled/faulty sensor that is not reading correctly, or a failure of the processor on the main board.

Whichever of the two problems you have, I would recommend that you have a Gledhill specialist look at it.
Here is a link to the correct manual for your model http://www.gledhill-spares.net/documents/SysteMateIII.pdf
Midland Boilercare
Midland Boilercare

Posts : 159
Join date : 2009-07-15

http://www.midlandboilercare.co.uk

Back to top Go down

How to change DHW Temperature? Empty Re: How to change DHW Temperature?

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum