New Board stopped working after 4 weeks

[Gallagher Boilers]

I replaced a control board in December (blank display) just returned to change the corroded pump valve and the board is not working correctly examining with a torch there is a chip burnt. UF3 on the board and on the back it doesn’t look like it’s been soldered.
Check pumps 200 ohs. Fitted a new board it’s now all good.

[Gallagher Boilers]

[mmartin]

Hi I can most likely repair that for you. Get back to me if you would like it sorting out. Website = https://murraymartin.yolasite.com/
or www.murraymartin.co.uk

Regards Murray

[MarkPTM29]

I can vouch for Murray as he has repaired a system board for my daughter’s Gledhill.
From my limited experience if one of these are burned out it’s usually because the associated pump is running constantly.
Regards
Mark

[Sponsored content]