Pulsacoil 2000 T1 sensor

Go down

Pulsacoil 2000 T1 sensor

Post  Lucav on Sat Jul 28, 2012 5:26 am


I had not hot water (just tepid) and flashing led light suggested I had both sensors faulty. I've just manage to change both PHE return sensor and the DHW temperature sensor. Unfortunately once I turned on the boiler the led light blinks 7 times pause and 7 times again (if I hear carefully there is also a mild buzzing noise) suggesting the T1 is faulty. I ask myself what are the odds!? . I notice that there is not current running through any of the Rod Thermostats, is this because the DHW senso appear to be faulty "again"?

What would you suggest to do next?..

Thanks for helping



Posts : 1
Join date : 2012-07-28

View user profile

Back to top Go down

Re: Pulsacoil 2000 T1 sensor

Post  mike on Wed Aug 01, 2012 3:03 pm

The rod stats are not controlled by the DHW or PHE sensors.
Is the a relay on your unit?
Also check the sensors are wired correctly.


Posts : 1728
Join date : 2009-10-08
Age : 65
Location : Norwich

View user profile http://www.mgch20.co.uk

Back to top Go down

Check the following also

Post  sunny.sahdev on Sat Sep 21, 2013 4:47 am

The sensors are connected to the PCB, check they have been wired correctly and you are receiving voltage to your pump. Also check your overheat stat has not tripped which will prevent electricity reaching your thermostat rods.


Posts : 383
Join date : 2013-08-21
Age : 33
Location : Vedhas Limited, 960 Capability Green

View user profile http://www.vedhas.co.uk/vedhas-what-we-do/pulsacoil-repair/#

Back to top Go down

Re: Pulsacoil 2000 T1 sensor

Post  Sponsored content

Sponsored content

Back to top Go down

Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum