DHW pump over-run
2 posters
Page 1 of 1
DHW pump over-run
Hi
first may I say what a great forum...
My SyteMate III is coming up to 10 years old and had been fairly reliable. Recently, after running the hot water tap, the DHW pump continues to run and will only switch off when I turn the HW tap on/off a few times. I suspect the flow switch, however I would appreciate any advice? - Steve
first may I say what a great forum...
My SyteMate III is coming up to 10 years old and had been fairly reliable. Recently, after running the hot water tap, the DHW pump continues to run and will only switch off when I turn the HW tap on/off a few times. I suspect the flow switch, however I would appreciate any advice? - Steve
stevie b- Posts : 2
Join date : 2010-12-31
Re: DHW pump over-run
Flow switch.
Sensors
PCB
But as it stops when the tap is turned on and off a few times points to the flow switch.
They are my thoughts with out being in front of the unit.
But you have posted that you have sorted it out.
Was it any of the above?
Or something weird and wonderful ( when found the fault is always wonderful ! )
Mike
MGC/H2O
Norfolk
Sensors
PCB
But as it stops when the tap is turned on and off a few times points to the flow switch.
They are my thoughts with out being in front of the unit.
But you have posted that you have sorted it out.
Was it any of the above?
Or something weird and wonderful ( when found the fault is always wonderful ! )
Mike
MGC/H2O
Norfolk
Similar topics
» New pump and PSC board, system working, pump constantly buzzing ?
» strange boiler problem
» PSB and Pump replaced Pump humming and getting hot
» Pulsacoil 2000 Blowing Chip UF2
» CHANGE OF TEMEPATURE
» strange boiler problem
» PSB and Pump replaced Pump humming and getting hot
» Pulsacoil 2000 Blowing Chip UF2
» CHANGE OF TEMEPATURE
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|