stopped working!!

View previous topic View next topic Go down

stopped working!!

Post  lcollins on Sat Jun 05, 2010 12:10 pm

Hi Mike

From one evening to the other my pulsar coil stopped working!

Previoulsy this has happened and i changed the DHW sensor and instaled new temp sensors in the heating elements.

This time i have changed the DHW sensor again, the heating elements are reading 19 homs +-.5 i believe this is ok?. but still there not heating up, normally the brass threads are tepid to the touch! neither the top or bottom are at the moment.. any ideas please??

also can you confirm that when the off peak is on only the bottom element is supposed to be heating and drawing current and when i turn on the boost then the top element starts to hea up and the biottom one doesnt?

lcollins

Posts : 6
Join date : 2009-03-17

View user profile

Back to top Go down

Re: stopped working!!

Post  mike on Thu Jun 10, 2010 5:29 pm

Is the unit getting hot?
Yes weird but both heaters will work at once!
Mike.

mike

Posts : 1626
Join date : 2009-10-08
Age : 64
Location : Norwich

View user profile http://www.mgch20.co.uk

Back to top Go down

Could be the thermostat rods

Post  sunny.sahdev on Fri Sep 13, 2013 6:45 am

Check out the thermostat rods, if they have tripped, it won't give power to the elements for them to heat up.

sunny.sahdev

Posts : 383
Join date : 2013-08-21
Age : 31
Location : Vedhas Limited, 960 Capability Green

View user profile http://www.vedhas.co.uk/vedhas-what-we-do/pulsacoil-repair/#

Back to top Go down

Re: stopped working!!

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum